Table of Contents
Advertisement
Programmable Settings
Date and Time
We recommend you set the date and time so that the unit will announce the day
and time each message was recorded when you play back messages.
1
Press [FUNCTION/EDIT].
2
Press [ ] at "Telephone".
3
Scroll to "Date and time" by pressing [ ]
or [ ], then press [ ].
4
(1) Enter 2 digits each for the month, day and
year. (Ex. To set May 15, 2004, enter "05
15 04".)
(2) Enter 4 digits for the time (hour and
minute). (Ex. To set 9:30, enter "0930".)
• If you enter a wrong number, press [ ] or [ ] to
move the cursor to the incorrect number. Enter
the correct number.
5
Select "AM" or "PM" by pressing [ ].
6
Press [ ] (Save).
• If a long beep sounds, the setting is not correct. Start again from step 4.
• The clock starts working.
7
Press [STOP].
• When entering the time, you cannot enter numbers greater than 12. Do not use
military time. (To set 13:00 hours, enter "0100", and select "PM"
The date and time may be incorrect after a power failure. When "
the base unit display, set the date and time again.
For Caller ID service users (p. 33)
• When a call is received, Caller ID information adjusts the date and time if the
time is incorrect.
• Caller ID information will automatically adjust the date and time for daylight
saving time.
• If the date and time have not been previously set, Caller ID information will not
adjust the date and time.
18
Base Unit
Telephone
Date and time
Date:22.31.2004
1
Time:12:00 AM
0-9=Date&Time
=AM/PM
=Save
Date:05.15.2004
Time:09:30 AM
AM
0-9=Date&Time
=AM/PM
=Save
.)
" flashes on
Advertisement
Table of Contents
