Panasonic KX-TG2258 Operating Instructions Manual page 57

General
Problem
The unit does not work.
The unit does not announce
the displayed caller's name.
The unit does not announce
the displayed caller's name
properly.
Previously programmed
information is erased.
"Recharge battery" is
displayed, " " flashes or
the unit beeps intermittently.
You charged the battery fully,
but "Recharge battery" is
still displayed and/or "
continues to flash.
The IN USE/CHARGE
indicator light does not go out
after the battery has been
charged.
For assistance, please call: 1-800-211-PANA(7262)
• Check the settings (p. 8–9).
• Check whether the dialing mode setting is
correct (p. 13).
• Charge the battery fully (p. 8).
• Clean the charge contacts and charge again
(p. 9).
• Install the battery properly (p. 8).
• Place the handset on the base unit and
unplug the AC adaptor to reset it. Plug in, and
try again.
• Re-install the battery (p. 8) and charge it fully.
• The handset and base unit ringer volumes
are OFF (p. 17).
• The Talking Caller ID feature is OFF (p. 15).
• Name pronunciation may vary. Name
pronunciation quality is based on names
most commonly used in the United States.
• The unit will announce each letter of
abbreviations, such as Co., Inc., etc.
• Caller ID service supports names of up to
15 letters. If the caller's name has more than
15 letters, the name will not be announced
correctly.
• If a power failure occurs, programmed
information may be erased. Reprogram if
necessary.
• Charge the battery fully (p. 8).
• Clean the charge contacts and charge again
(p. 9).
" • Install a new battery (p. 8).
• This is normal.
Troubleshooting
Cause & Remedy
57