Troubleshooting - Panasonic KX-TG2205W Operating Instructions Manual

Troubleshooting

Problem
The unit does not work.
An alarm tone sounds.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
The unit does not ring.
You cannot program items
such as the dialing mode.
Previously programmed
information is erased.
You cannot store a phone
number in memory.
24
Remedy
•Check the settings (p. 7–11).
•Charge the battery fully (p. 8).
•Clean the charge contacts and charge
again (p. 9).
•Install the battery properly (p. 8).
•Place the handset on the base unit and
unplug the AC adaptor to reset. Plug in,
and try again.
•Re-install the battery and place the
handset on the base unit (p. 22). Try
again.
•You are too far from the base unit. Move
closer and try again.
•Place the handset on the base unit and
try again.
•Plug in the AC adaptor.
•Raise the base unit antenna.
•Locate the handset and the base unit
away from other electrical appliances
(p. 3).
•Move closer to the base unit.
•Raise the base unit antenna.
•Press
to select a clearer channel in
Ü
the talk or speakerphone mode.
•The ringer volume is set to OFF. Set to
HIGH or LOW (p. 11).
•Programming is not possible while the
unit is in the talk mode.
•Do not pause for over 60 seconds while
programming.
•Move closer to the base unit.
•If a power failure occurs, programmed
information may be erased. Reprogram
if necessary.
•You cannot store a number while the
unit is in the talk mode.
•Do not pause for over 60 seconds while
storing.