Operation - MULTIQUIP MTX-90 Operation And Parts Manual

Operation

1. To start the rammer tamping action, move the throttle lever
(Figure 9) quickly from IDLE to the START (
DO NOT move the throttle lever slowly as this may cause
damage to the clutch or spring.
Figure 9. Throttle Lever (Start Position)
CAUTI CAUTI
CAUTI CAUTI CAUTION
Make sure that the throttle lever is moved to the FULL START
position. Operating the rammer at less than full speeds can
result in damage to the clutch springs or foot.
2. The MTX-80/MTX-90 tamping rammer is designed to run at
3,600/3700 rpm. At optimum rpm the foot hits at the rate
between 590 ~ 695 impacts per minute. Increasing throttle
speed past factory set rpm does not increase impacts and
may damage unit. The MTX-80/MTX-90 is designed to ad-
vance while tamping. For faster advance, pull back slightly
on the handle so that rear of foot contacts soil first.
3. To stop the tamping action, move throttle lever quickly from
START to IDLE position (Figure 10).
Figure 10. Throttle Lever (Idle Position)
PAGE 16 — MTX-80/MTX-90 — OPERATION AND PARTS MANUAL — REV. #2 (10/04/07)
) position.
THROTTLE LEVER
(START POSITION)
THROTTLE LEVER
(IDLE POSITION)
MTX-80/MTX-90 — OPERATION
Stopping The Engine
Normal Shutdown
1. Move throttle lever quickly from the START to IDLE position
(Figure 10) and run the engine for three minutes at low speed.
After the engine cools , move the throttle lever to the STOP
position (Figure 11). The engine will stop and the fuel cock
is automatically closed.
Figure 11. Throttle Lever (Stop Position)
2. If the engine does not stop due to a problem with the switch
or the like, move the machine to a safe location and hold the
throttle lever in the stop position. Let the machine run on idle
and the machine will stop after a few minutes.
THROTTLE LEVER
(STOP POSITION)