Step 3. Initial Pump, Engine & High Pressure Hose Preparation - North Star M157595BE Owner's Manual

Step 3. Initial Pump, Engine & High Pressure Hose Preparation
Prepare Verify pump oil level.
Water Pump Note: The pump is shipped with oil. *Change oil after first 40 hours, then every 3
months or 500 hours
1. Verify oil level:
2. If oil level is low, fill using
3. Replace oil fill cap.
Prepare Fill the engine with oil.
Engine Note: The engine is shipped without oil.
Refer to the Engine Manual to locate oil-fill port and for instructions on filling.
Use the oil grade and quantity specified in the Engine Manual.
Prepare High Completely unwrap / unwind the high pressure hose from the hose reel.
Note: New hose will "grow" when charged for the first time and should always be
Psi Hose on
Hose Reel charged one time before being wrapped on the reel.
Assembly and Initial Set-Up
a. Remove shipping tape
and black vent plug (if
present) from oil fill cap.
Verify that oil level is half
way up the sight glass (or at
the indicator line on the dip
stick, if equipped).
SAE30 non-detergent oil or Cat
Pump Oil Item #22158.
Sight Glass
Oil drain
15
Oil fill cap