Advertisement
Remove the old gasket from the floor
and the closet flange with a putty knife.
Remove the old T-bolts and discard
them.
NOTICE:
if the new toilet is not
installed immediately, temporarily stuff
a rag into the closet flange.
Install two new 8mm (5/16") diameter
T-bolts into the closet flange.
NOTICE:
Do not use white cement or
high lime content cements to install
this toilet. The expansion of cement
due to a rise in temperature may make
the toilet crack or cause damage.
Kohler is not responsible for any
damage caused by installation with the
use of cement.
TO INSTALL SUPPLY
SHUT-OFF VALVE
Install the supply shut-off valve so it is
67mm (2-5/8") above the finished floor
line, and 194mm (7-5/8") to the left of
the closet flange centerline.
The centerline of the supply shut-off
valve outlet should extend 67mm
(2-5/8") from the finished wall. Install
the supply shut-off valve with the outlet
vertical.
TO INSTALL BOWL
Set the bowl upside down on some
padding. Firmly press the toilet gasket
onto the toilet outlet.
NOTE 1:
Wax ring type toilet gasket
should not be installed at temperatures
less than 21 .
NOTE 2:
If you are using a toilet
gasket with an integral plastic sleeve,
make sure the gasket is positioned
with the sleeve facing away from the
toilet.
If you temporarily plugged the closet
flange with a rag, remove the rag at
this time and ensure that the drain pipe
is clear and free of debris.
Carefully align and lower the bowl over
the closet flange and T-bolts. Apply full
body weight to the bowl rim to set the
seal.
CAUTION: Risk of concealed
leakage:
Do not lift or rock the
bowl after placement - a new
toilet gasket must be installed if
you break the watertight seal.
1033005-T01-J
Closet Flange
Fig.#2
2
T-bolts
T
Closet Flange
Fig.#3
3
Supply Shut-Off Valve
194
67
Closet Flange
Centerline
305
Fig.#4
4
Toilet Outlet (OUTLET)
Toilet Gasket
Fig.#5
5
-3-
8mm
T
mm
1
21
2
T
67
194
mm
67mm;
Advertisement
