Panasonic HM-TA2 Operating Instructions Manual page 84

Do not spray insecticides or volatile chemicals onto the unit.
≥ If the unit is sprayed with such chemicals, its body may be marred and
the surface finish may peel off.
≥ Do not leave rubber or plastic products in contact with the unit for a
long time.
When you use the unit in a sandy or dusty place such as a beach,
do not let sand or fine dust get into the body and terminals of the
unit.
≥ Sand or dust may damage the unit. (Care should be taken when
inserting and removing a card.)
HM-TA2
Keep the unit away from sea water.
≥ If sea water splashes onto the unit, wipe off the water with a well wrung
cloth. Then wipe the unit again with a dry cloth.
Do not use the unit for surveillance purposes or other business
uses.
≥ In certain situations, continuous use could cause the unit to overheat
and cause a malfunction. Such use is strongly discouraged.
≥ This unit was designed for consumer intermittent use. It was not
intended for continuous use, or for any industrial or commercial
application resulting in prolonged use.
Perform a formatting of the built-in memory when this unit is to be
disposed/transferred. (l 58)
About status indicator during charging
When the status indicator is flashing at a particularly fast rate, the
following should be considered.
Flashing with approx. 2 second period (off for approx. 1 second, on
for approx. 1 second):
≥ The battery is not charged. Press the RESET button, and try charging
again.
≥ Check that the terminals of the unit are not dirty or covered with a
foreign object, and connect this unit correctly once again. If a foreign
object or dirt is present, turn off the unit and then remove it.
84
VQT3P01