Other Functions - Panasonic AG-DVX100B Setup

4.6 OTHER FUNCTIONS Screen
Item
REMOTE
DV CONTROL
DV CMD SEL
REC LAMP
BEEP SOUND
CLOCK SET
TIME SHIFT
TAPE PROTECT
USER FILE
HOUR METER
Remote
This item is used to set the operations of the wireless remote control. There are
3 settings, VCR1, VCR2 and OFF. When using two DVX-100's this setting allows the two
camcorder to be control from one remote control, by selecting which camcorder you want to
control from the remote control. This item makes sure that only that one button (VCR1 or
VCR2) will operate this camcorder from the remote control. OFF the remote will not be able
to control the camcorder.
IEEE 1394
Or firewire as it is often called is an extremely high speed, high performance
Serial Bus with a special protocol (set of rules). Part of that protocol has been used for high
speed digital video and audio transfer. Not only can you transfer video and audio, you can
transfer time code and control your VCR remotely. The cable used must not be longer then
4.5 meters.
DV Control:
This item selects the method for backup recording, using the DV (1394)
connector located on the side, under a cover of the DVX-100. There are 4 selections:
OFF: There is no control information supplied.
EXT: The START/STOP button will control the backup recording. In this mode only the
backup recorder will record the video and audio. The camcorder does not record.
BOTH: The video is recorded on both the camcorder and the backup unit.
CHAIN: used when additional record time is needed. Once the camcorder approaches the
end of its record time the backup unit will automatically start recording. Remember the back
up unit must be in the record standby mode to function.
Settings
VCR1, VCR2, OFF
OFF, EXT, BOTH, CHAIN
REC P / STOP
OFF, FRONT, REAR, BOTH
OFF / ON
SETS INTERNAL CALENDAR
+23h, +1h, OFF, -1h, 23h
POWER OFF / STBY
LOAD, SAVE, INITIAL
VIDEO HEAD HOUR METER
Default
VCR1
OFF
REC P
OFF
OFF
YES
OFF
POWER OFF
- - - -
00000H
27