Panasonic AG-DVX100B Setup page 23

First Rec TC
This item allow the user to select the time code that will be used when
recording is started.
REGEN: In this mode the time code is regenerated from the time code on the video tape if
there is any.
PRESET: Here the time code is recorded using the value set in the TC PRESET item serv-
ing as the initial value.
TC PRESET
This item is used to set the initial value used, when the PRESET in First Rec
TC is selected.
Note: When the 24P or 24P ADV modes are used you must set the frame value to 0 or a
multiple of 5. If you use any other value the time code recorded will shift.
UB Mode
This item allows the user to set up the information to be recorded as user bits.
The user may select one of 5 items:
User:
the user's information, which is selected in the UB PRESET item.
Time:
The time that the recording was made.
Date:
The date that the recording was made.
TCG:
The time code generator's value is recorded.
FRM Rate: Is t
he frame rate information for frame conversion is recorded. This is a 8 bit
digital number, which contains the following information: The user's bit value verification
information, the frame sequence number, the frame rate information and the recording con-
trol information.
UB Preset
This item is used for setting the user's bit, make sure that USER is selected in
the UB Mode item setting. The user's bit has 8 bits, which can be set 0 to 9, A to F
Interval Rec
This item sets the intermittent recording mode, you have 3 selections.
OFF: The Intermittent operation function is turned off.
ON: When the START/STOP button is pressed, recording will be performed for the num-
ber of seconds set by the REC TIME item and the INTERVAL TIME item.
One-Shot: This item will set the camcorder into a time lapse recording mode. When the
START/STOP button is pressed, the VCR will go into the recording mode controlled by the
seconds that were set up in the REC TIME item, then go into the record pause mode.
Note: When placed into the intermittent recording mode or one-shoot, an "I" will flash on the
EVF and display it on the top of the screen. Once the recording has started it will stop
flashing. If the power is turned off the Interval Rec will return to OFF. When in the 24P or
24P ADV modes you will not be able to use the Interval Rec function.
Rec Time
This item is used to set the recording duration for which intermittent recording is
to be performed. Normally set to 0.5 seconds, you can change this to 1 second, 1.5 second
or 2 seconds.
Interval Time
This item sets the duration of the interval time with which intermittent re-
cording is to be performed. Normally set to 30 seconds, you can change this to 1 minute,
5 minutes or 10 minutes.
23