Panasonic AG-DVX100B Setup page 32

TCG
This item selects FREE RUN OR REC RUN, as explain its best to leave in the REC
RUN mode.
First Rec TC
This item allow the user to select the time code that will be used when
recording is started.
PRESET: here the time code is recorded using the value set in the TC PRESET item serv-
ing as the initial value.
REGEN: in this mode the time code is regenerated from the time code on the video tape
TC PRESET
This item is used to set the initial value used, when the PRESET in First Rec
TC is selected.
Note: When the 24P or 24P ADV modes are used you must set the frame value to 0 or a
multiple of 5. If you use any other value the time code recorded will shift.
1394 UB Regen
This item selects the user's bit to be recorded when the DV connector is
used.
OFF: The user's bit selected in the UB Mode item is used for the recording.
ON: The user's bit of the signals input of the DV connector is used for recording.
Note: When set to ON, this setting takes precedence over the UB MODE item setting.
The user's bit is not recorded if the signal does not contain the user's bit information
And when there is no signal supplied to the DV connector the UB MODE item is used.
UB Mode
This selection allows the user to set up the information to be recorded as user
bits. The user may select one of 5 items:
User:
the user's information, which is selected in the UB PRESET item.
Time:
The time that the recording was made.
Date:
The date that the recording was made.
TCG:
The time code generator's value is recorded.
FRM Rate:
The frame rate information for frame conversion is recorded. This is a 8 bit
digital number, which contains the following information. The user's bit value verification
information, the frame sequence number, the frame rate information and the recording con-
trol information.
UB Preset
This item is used for setting the user's bit, make sure that USER is selected in
the UB Mode item setting. The user's bit has 8 bits, which can be set 0 to 9, A to F
32