Placing The Ups In Operate Mode - Compaq Presario 3000 Series Operation And Reference Manual

Compaq operation and reference guide ups 3000 series
Hide thumbs Also See for Presario 3000 Series:
Table of Contents

Advertisement

Placing the UPS in Operate Mode

The Compaq 3000 Series UPS may be placed in Operate mode if either of the
following conditions apply:
The UPS is powered up and in Standby mode (LED 16 is off)
The UPS is powered off; no utility power is available
Press and hold the ON button ( ) until the LED 16 (ON LED
indicating that power is available at the UPS output receptacles. The UPS
acknowledges compliance with a short beep.
IMPORTANT: If using battery power (no utility power present), press the ON button and
hold for three seconds. The UPS will conserve battery power by omitting the self-test.
Figure 3-2. Operate mode controls
ON LED
ON button
STANDBY button
1
2
3
Operation 3-9
) turns green,

Advertisement

Table of Contents
loading

This manual is also suitable for:

800 series3000 series

Table of Contents

Save PDF