Icommissioning; Preliminary Checks, Adjustments And Operational Tests; Electrical And Plumbing Connection; Fitting Of Filters And Overflows - Electrolux EFTD052E Installation Manual

ON button and POWER indicator
light
OFF button
START button
PAUSE button
Wash SPEED 1 button
Wash SPEED 2 button
Wash tank temperature display
Boiler temperature display
I COMMISSIONING
I.1 Preliminary checks, adjustments and
operational tests
Before starting the machine, check:
1. electrical and plumbing connections;
2. positioning of tank components;
3. washing and rinse arms position and fitting;
4. curtains position and fitting.
These operations must only be carried out by specialized
technicians provided with adequate personal protection equip-
ment (refer to A.3 Personal protection equipment), tools and
suitable ancillary equipment with the machine switched off and
cold.
I.2

Electrical and plumbing connection

Before starting the machine, check:
1. correct connection of the electrical wires that feed the
machine;
2. the power supply voltage and frequency match the data
given in the technical data table (E.1 Main technical
characteristics);
3. correct connection of the water supply and drain pipes
(G.6 Plumbing connections);
4. guards, safety devices and emergency switches are in
place and properly installed.
Press this button to switch the appliance on. The Power indicator light
is on and the water start to fill the tanks. After some minutes also the
tank heating elements start to warm the water.
The red indicator light of the pause button
second during the filling and heating phases.
When the dishwasher is ready to work the green indicator light of the
start button flashes 2 times and for 2 second is off.
Press the OFF button to switch the appliance off.
The POWER indicator light is off.
Press this button to start the washing cycle.
Press this button to stop the washing cycle.
Press this button to set the conveyor belt at the low speed. It is suitable
for heavily soiled dishes.
Press this button to set the conveyor belt at the high speed. It is
suitable for normally soiled dishes.
It shows the temperature of the water inside the wash tank.
It shows temperature of the water inside the boiler.
I.3

Fitting of filters and overflows

CAUTION
The below operations must be performed
when the machine is cold and switched off.
Make sure that:
1. the inlet filter is correctly installed;
blinks alternately every
45