Table of Contents
Advertisement
• Join the beginning and the end of the conveyor belt.
2
• Remove the lower panel of the unloading module and
connect the conveyor belt with the motor.
2
3
1
1
3
• Check the tension of the conveyor belt and, if necessary,
adjust it.
• Refit all panels previously removed.
Level the machine
• Adjust the equipment by turning the special adjustable feet.
Make sure it is perfectly level, both length wise and
crosswise.
Remove protective film
• Carefully remove the protective film from the outer plate
without tearing it, to avoid leaving traces of glue.
G.5
Disposal of packing
The packing must be disposed of in compliance with the
current regulations in the country where the appliance is used.
All the packing materials are environmentally friendly.
They can be safely kept, recycled or burned in an appropriate
waste incineration plant. Recyclable plastic parts are marked
as follows:
Polyethylene
• Outer wrapping
• Instructions bag
Polypropylene
• Straps
Polystyrene foam
• Corner protectors
The parts in wood and cardboard can be disposed of,
respecting the current regulations in the country where the
machine is used.
G.6
Plumbing connections
IMPORTANT
Watermark labelled appliances must be installed in
accordance with AS/NZS 3500.1 and drainage to
be in accordance with 3500.2.
Install the machine water inlets and drain pipes
according to the plumbing circuit and installation
diagrams.
37
Advertisement
Table of Contents
