Ford Everest 2006 Manual page 241

EVEREST_F8K4-10-06H_Edition1 Page243
Friday, August 11 2006 10:38 AM
Front direction indicator lights,
Parking lights
1. If you are changing a bulb in the right
headlight unit, start the engine, turn the
steering wheel all the way to the right,
and turn off engine. If you are
changing a bulb in the left headlight
unit, turn the steering wheel to the left.
2. Make sure the headlight switch is off.
3. Turn the centre section of the plastic
retainers anticlockwise and remove
them, then partially peel back the
mudguard.
Removal
Installation
4. Turn the socket and bulb assembly
anticlockwise and remove it.
5. Disconnect the bulb from the socket.
Form No.F8K4-10-06H
Parking lights
Front direction indicator
lights
Black plate (243,1)
Owner Maintenance
6. Install the new bulb in the reverse order
of removal.
Side direction indicator lights
1. Slide the unit as shown in the figure to
remove it.
2. Detach the electrical connector from
the unit by pulling it to the rear.
3. Install the new side direction indicator
unit.
4. Insert the front end of the unit into the
vehicle and press in the rear end.
NOTE
Bulb replacement is not possible
because it is built into the unit. Replace
the unit.
Maintenance and Care
8-31