Onkyo UWL-1 Instruction Manual page 3

Precautions
1. Recording Copyright—Unless it's for per-
sonal use only, recording copyrighted material
is illegal without the permission of the copy-
right holder.
2. Care—Occasionally you should dust the unit
all over with a soft cloth. For stubborn stains,
use a soft cloth dampened with a weak solution
of mild detergent and water. Dry the unit
immediately afterwards with a clean cloth.
Don't use abrasive cloths, thinners, alcohol, or
other chemical solvents, because they may
damage the finish or remove the panel letter-
ing.
3. Power
Pressing the [STANDBY/ON] button to select
Standby mode does not fully shutdown the
unit. If you do not intend to use the unit for an
extended period, remove the power cord from
the AC outlet.
4. Never Touch this Unit with Wet Hands—
Never handle this unit or its power cord while
your hands are wet or damp. If water or any
other liquid gets inside this unit, have it
checked by your Onkyo dealer.
5. Handling Notes
• If you need to transport this unit, use the
original packaging to pack it how it was
when you originally bought it.
• Do not leave rubber or plastic items on this
unit for a long time, because they may leave
marks on the case.
• This unit's top and rear panels may get
warm after prolonged use. This is normal.
• If you do not use this unit for a long time, it
may not work properly the next time you
turn it on, so be sure to use it occasionally.
For U.S. models
FCC Information for User
FCC WARNING
Changes or modifications not expressly approved
by the party responsible for compliance could void
the user's authority to operate the equipment.
NOTICE:
This equipment has been tested and found to com-
ply with the limits for a Class B digital device, pur-
suant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio communica-
tions. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If
this equipment does cause harmful interference to
radio or television reception, which can be deter-
mined by turning the equipment off and on, the
user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is con-
nected.
• Consult the dealer or an experienced radio/TV
technician for help.
FCC ID: ATMUTX1
MODEL: UTX-1
IC No.: 6547A-UTX1
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
This transmitter must not be co-located or operated
in conjunction with any other antenna or transmit-
ter.
3