Onkyo UWL-1 Instruction Manual page 17

Troubleshooting—Continued
Audio playback is noisy or distorted
• Depending on the location of the Transmitter, audio playback may be interrupted. Try moving
the Transmitter to another location. If you can't relocate your PC, using a commercially avail-
able USB extension cable and moving the Transmitter to another location may resolve the
issue.
• Select another wireless channel by pressing the Transmitter's [CH SELECT] button (see
page 14).
• If a radio or satellite dish is located nearby, it may cause interference.
• If a wireless computer network, microwave oven, or other device that uses the 2.4 GHz fre-
quency band is located nearby, audio playback may be interrupted. In this case, press the
Transmitter's [CH SELECT] button to select another wireless channel (see page 14).
• If there's an obstacle between the Transmitter and Receiver, audio playback may be inter-
rupted.
There's no sound when playing a CD in your PC's CD/DVD drive
• If your PC's CD/DVD drive does not support digital audio output, audio from the CD/DVD
drive will not be transmitted by the Transmitter and you will not be able to listen to CD play-
back through the audio system or powered speakers connected to the Receiver (see page 15).
Can't hear any music when playing PC games
• If the game uses the CD/DVD drive's audio output to output audio, see the previous item.
Audio playback is interrupted
• Audio playback may be interrupted if you connect or disconnect another USB device.
• During audio playback, don't perform any demanding tasks that will create additional work
for your PC's processor.
• If your PC's processor does not meet the system requirements stated on page 8, performance
may be affected. Even if the processor does meet the requirements, audio playback may be
interrupted if the processor is burdened with a heavy workload. In this case, quit all other pro-
grams.
• Turning off any energy saving settings may also improve performance.
Can't record on the component connected to the Receiver's optical digital jack
• For copyright reasons, it's not possible to record from the Receiver's optical digital jack.
Note: The UWL-1 uses microcomputers for signal processing and control functions. In very
rare situations, severe interference, noise from an external source, or static electricity may
cause it to lockup. In the unlikely event that this should happen, unplug the Transmitter and
the Receiver's AC adapter, wait at least 5 seconds, and then plug them back in again.
Recording
17