Setup 1 Page: Cdi Scale/Alarms; To Change The Cdi Scale; To Change The Ils Cdi Selection; Ils Cdi Window View - Garmin GNS 430 Pilot's Manual & Reference

Setup 1 Page: CDI Scale/Alarms

To change the CDI scale:

1) Select 'CDI/Alarms' from the Setup 1 Page
(Figure 10-58), using the steps described at
the beginning of this section.
Figure 10-58 CDI/Alarms Highlighted
2) The flashing cursor highlights the 'Selected CDI'
field. Turn the small right knob to select the
desired CDI scale. The selected scale and any
lower scale settings are used during the various
phases of flight as described at the beginning
of this section.
Press the ENT Key to accept the selected scale.
3)
The 'System CDI' field displays the CDI scale
currently in use (Figure 10-59). The 'System
CDI' setting may differ from the 'Selected CDI'
depending upon the current phase of flight.
Figure 10-59 Selected CDI Field Highlighted
190-00140-00 Rev. P

To change the ILS CDI selection:

1)
2)
3)
GNS 430(A) Pilot's Guide and Reference
Select 'CDI/Alarms' from the Setup 1 Page,
using the steps described at the beginning of
this section.
Turn the large right knob to highlight the
'Auto'/'Manual' ILS CDI field.
Turn the small right knob to select 'Auto' or
'Manual', as desired (Figure 10-60). Press the
ENT Key to accept the selection.
Figure 10-60 ILS CDI Window
SECTION 10
AUX PAGES
10-23