To Select An Approach And Automatically Tune The Proper Vloc Frequency - Garmin GNS 430 Pilot's Manual & Reference

4) Press the ENT Key to place the frequency in
the standby field of the VLOC Window (Figure
9-6).
Figure 9-6 Frequency in Standby Field
Press the VLOC Flip-flop Key to activate the
5)
selected frequency.
6) Press the small right knob to remove the
flashing cursor.
NOTE: For duplex COM operations, the VLOC
receiver may be auto-tuned from the Nearest
Flight Service Station Page. See Section 8.8 for
more info.
When selecting a VOR or ILS approach, manual
tuning of the VLOC receiver is not required. Once the
approach procedure is 'Loaded' or 'Activated', the GNS
430 automatically places the proper frequency in the
standby field of the VLOC Window. To use this frequency,
press the VLOC Flip-flop Key to activate the frequency.
Additional information on approach procedures is
provided in Section 6.1.
190-00140-00 Rev. P
To select an approach and automatically
tune the proper VLOC frequency:
1)
2)
3)
4)
5)
GNS 430(A) Pilot's Guide and Reference
VLOC RECEIVER
Select the destination airport using the Direct-
to Key or as the last waypoint in the active
flight plan.
Press the PROC Key to display the Procedures
Page.
Turn the large right knob to highlight 'Select
Approach?' and press the ENT Key (Figure
9-7).
Figure 9-7 Procedures Page
A window appears listing the available
procedures. Turn the small right knob to
highlight the desired procedure and press the
ENT Key. (When a direct-to destination is
selected, departures are offered for the nearest
airport.)
A second window appears listing available
transitions. Turn the small right knob to
highlight the desired transition waypoint and
press the ENT Key. (The approach 'Vectors'
option assumes the pilot will receive vectors to
the final course segment of the approach and
will provide navigation guidance to intercept
this final course.)
SECTION 9
9-3