Course From Fix Flight Plan Legs; Kpmd Approach; Map Page View - Garmin GNS 430 Pilot's Manual & Reference

Course From Fix Flight Plan Legs

Certain approach, departure, and arrival procedures
in the Jeppesen database contain course from fix flight
plan legs. The GNS 430 is able to load these legs into the
flight plan along with the rest of the procedure data, and
provide navigation along these legs.
There are three different types of course from fix legs:
• Course from fix to distance, or Course from fix to
DME distance
• Course from fix to altitude
• Course from fix to manual sequence
Course from fix to distance legs appear in the flight
plan like normal waypoints, but the destination name
always begins with a 'D', followed by a distance in nm
from the waypoint fix (Figure 6-59).
Figure 6-59 Active Flight Plan Page



DO NOT USE FOR NAVIGATION
Figure 6-60 KPMD Approach
190-00140-00 Rev. P
Palmdale (CA) AF Plant 42
VOR/DME or GPS Rwy 25




 
GNS 430(A) Pilot's Guide and Reference
This example uses the VOR/DME RWY 25 approach into
Palmdale, California (KPMD) and includes a teardrop course
reversal (refer to Figure 6-60 for the following steps).
1) At the initial approach fix (PMD), a waypoint
alert ('NEXT DTK 070°') appears in the lower
right corner of the screen. As the distance to
the IAF approaches zero, the alert is replaced
by a turn advisory ('TURN TO 070°'). Dial the
outbound course into the CDI (or HSI) using
the OBS knob.
2) Fly the 'course from fix to distance' leg, as
shown on the Active Flight Plan Page and
the Default NAV Page (Figures 6-61 and
6-62). Note the magenta line in Figure 6-62,
which represents the currently active leg of
the approach. The distance (DIS) displayed on
the above screens is TO the 'D13.0' point. The
flight plan automatically sequences to the next
leg upon reaching 'D13.0'.
Figure 6-61 Default NAV Page
Figure 6-62 Map Page
SECTION 6
PROCEDURES
6-21