HP MSM317 Installation And Configuration Manual page 49

Diagnostic
Indicates the status of the controller with regards to management by the team.
Diagnostic
Configured
Detected
Establishing tunnel
Firmware failure
Installing firmware
Not authorized
Not responding
Rebooting
Resetting configuration
Restoring configuration
Synchronized
Unconfigurable
Unsupported product
Uploading configuration
Uploading firmware
Validating capabilities
Validating configuration
Validating firmware
Waiting for acceptance
Action
Indicates the recommended action to apply to a controller to resolve a diagnostic condition.
Description
The controller is configured as part of the team.
The controller sent a discovery request to the team manager and the
team manager has replied.
A secure management connection is being established between the
team manager and the controller.
New software failed to upload to the controller. The manager will retry
soon.
New software has been successfully uploaded to the controller. The
controller will restart to activate the new software.
The controller has not yet been authorized to join the team. Authorization
must be performed manually by an administrator by clicking Authorize
in the Action column.
The controller has stopped sending management information to the team
manager. Rediscovery may re-establish the connection. If not, and
network failure may have occurred or the controller may be inoperative.
The controller is restarting.
The controller's configuration is being reset to factory defaults. This is
normal and will occur when the software version on the manager is
changed or if the controller is not synchronized.
The controller is currently restoring its previous configuration settings.
The controller had its software and configuration settings successfully
updated by the team manager and is fully operational.
The controller cannot be added because the team already has the
maximum number of supported members. To add the controller you must
first remove one or more team members.
The product type of the controller is not supported on this team. All
controllers must have the same product type as the team manager.
Configuration settings are currently being sent to the controller.
The team manager is uploading new software to the controller. Wait
until the operation completes.
The capabilities of the controller are being identified by the team
manager.
The team manager is waiting for the controller to send its configuration.
The team manager is waiting for the controller to send its software
version number.
The controller has been authorized by the team manager. However, the
controller has not yet decided to join this team. (If multiple managers
replied to the controller's discovery request, the controller may choose
to connect with another team.)
Viewing status information 49