Table of Contents
Advertisement
B080C01A-AAT
Adjusting Seatback Angle
To recline the seatback, lean forward to take
your weight off it, then pull up on the recliner
control lever at the outside edge of the seat.
Now lean back until the desired seatback angle
is achieved. To lock the seatback into position,
release the recliner control lever.
WARNING:
To minimize risk of severe injury in the
event of a collision or sudden stop, both the
driver and passenger seatbacks should al-
ways be in a nearly upright position while
the vehicle is in motion. The protection pro-
vided by the seat belts and airbags may be
reduced significantly when the seatback is
reclined. There is greater risk that the driver
and passenger will slide under the belt which
may result in serious injury if a crash occurs
when the seatback is reclined.
1- 6
FEATURES OF YOUR HYUNDAI
B080D02A-AAT
Adjustable Headrests
AX10120A
Headrests are designed to help reduce the risk
of neck injuries.
To raise the headrest, pull it up. To lower it,
push it down while pressing the lock knob.
WARNING:
o For maximum effectiveness in case of an
accident, the headrest should be adjust-
ed so the top of the headrest is at the
same height as the top of the occupant's
ears. The use of a cushion that holds the
body away from the seatback is not rec-
ommended.
o Do not operate the vehicle with the head-
rests removed as severe injury to an
occupant may occur in the event of an
accident. Headrests may provide protec-
tion against severe neck injuries when
properly adjusted.
B080E01A-AAT
Lumbar Support Control
(Driver's seat only) (If installed)
Lock knob
AX10130B
To adjust the lumber support, turn the handle
on the inboard side of the seat. To increase the
amount of lumbar support, pull the lever for-
ward. To decrease it, push the lever toward the
rear.
AX10140A
Hide quick links:
Advertisement
Table of Contents
