Epson Equity 386SX User Manual page 59

7. If the configuration of the hard disk you are installing does
not match one of the drive types listed in Appendix E,
highlight User
following:
Number of cylinders
The same parameter is highlighted on the submenu above.
Enter the correct number of cylinders (tracks) for the disk
and press
Enter.
Note Note
If you use the number keys on the numeric If you use the number keys on the numeric
enter parameters, press the enter parameters, press the
Num Lock mode. The Num Lock mode. The
mode mode
Num Lock Num Lock
The information for Number of cylinders is
automatically updated on the submenu above and you see
the next parameter,
correct number of read/write heads for the hard disk and
press
Enter.
Follow this
settings list (the number of sectors, the precompensation
cylinder, and the landing zone).
If you enter a parameter incorrectly, press T or 1 to
highlight the parameter and then enter it again.
The Setup program does not allow you to enter the total
storage capacity; it calculates the storage capacity for you,
based on what you enter for the number of cylinders, heads,
and sectors.
After you type the landing zone number and press
the cursor block returns to the
and press
defined
Num Lock Num Lock
Num Lock Num Lock
is enabled. is enabled.
Number of heads. Enter the
same procedure for each remaining item in the
Running the Setup Program
Enter. You
977
keypad to keypad to
key to enable key to enable
light is on when the light is on when the
submenu heading.
Drive
see the
I
Enter,
2-21