Epson Equity 386SX User Manual page 240

2. Type the number of the cylinder containing the bad track
and press
Enter head number
3. Type the head number for the bad track and press
To cancel the operation, press
When you complete a valid entry, it appears in the table and
you can add the next bad track, if necessary.
If you make a mistake, move the cursor block to the incorrect
track and press C to alter the track data or press
the track from the table. Change the track data just as you add a
track.
The maximum valid cylinder number and head number (nnnn
and nn) vary according to the capacity of the hard disk. If you
enter an invalid cylinder or head number, a reminder of the
range of values appears and the program asks you to enter the
value again.
When you finish adding all the bad tracks, press
typing a value. After you complete editing, check the entries in
the defective track table. When you are sure the table is correct,
press The program displays a warning about the consequences
F.
of proceeding with formatting.
Physically Formatting a Hard Disk
D-8
You see this prompt:
Enter.
(0
-nn):
without typing a value.
Enter
Enter.
to remove
D
without
Enter