Installing Circuit Boards - TRIGEM CW4D33E Operation Manual

Reconnect the keyboard to its connector on the rear panel
of the main system unit.
Place the video monitor on top of the main system unit
and connect the AC power and signal cables to their
correct sockets on the rear panel.
Reconnect any peripheral device to their rear panel I/O
port connectors.
Plug the AC power cable into the socket on the rear panel
of the main system unit and the main AC power outlet.

Installing Circuit Boards

Most of the expansion products you will be installing into your
computer are circuit boards. Like the system boards installed at
the factory, expansion boards are plugged into the main system
unit's mother board.
There are expansion boards available for a wide variety of
functions. The most common expansion boards provide such
functions as extra I/O ports, high resolution video graphics and
system memory expansion.
The basic computer is shipped from the factory with only the
system motherboard installed. If you have purchased a system
with a video monitor or a hard disk system installed, the
necessary controller board(s) should also be installed. If you are
adding these systems to a basic computer, or expanding your
system by installing additional hardware, follow the procedure
below to install the circuit boards.
First, read all of the instructions provided with the expansion
product. Then, carefully unpack the circuit board(s) to be
installed.
Expanding Your System
7-9