TRIGEM CW3S20A Operation Manual page 82

For now, type N. The system prompt will reappear. To
compare the backup diskette with the original, you will use the
DISKCOMP command. Enter the command at the system
prompt:
The computer will respond:
Remove the backup diskette from the drive, and put it in its
protective jacket. Set it aside for a moment, making sure that
you don't mix it up with the second blank diskette. Put the
original "master" MS-DOS main system diskette back into the
floppy disk drive, then press the SPACEBAR key. As with the
DISKCOPY command, your computer will read the entire
contents of the diskette into system memory, and will display:
When the computer is finished reading, the drive will rum off,
and the following message will appear:
Using MS-DOS With Your Computer
4-14