Internal Hard Disk Drive - TRIGEM CW3S20A Operation Manual

Figure 7-5. Mounting the Floppy disk drive
If you are to mount the internal hard disk drive inside the main
system unit case, follow the steps below:
Remove the cover from the main system unit, as described
previously.
Attach the hard disk drive next to the Floppy disk drive on
the right side of the system.
Screw the hard disk drive on the system using 4 screws.
Connect the hard disk drive controller cables (power cable
and signal cable) to the drive.
Replace the main system unit cover.
Expanding Your System 7-15