Wildcards - TRIGEM CW3S20A Operation Manual

To perform the operation in reverse, that is, to copy from the B
drive to the default drive, enter the command:
Note that this time, you were required to enter the source drive
letter before the filename. This is because, in this example,
drive B is not the default drive. However, since no drive letter
was specified for the target drive, MS-DOS copied the file onto
the default, or in this case, A drive.
It is also possible to copy a file between two disks when neither
one is the default drive. For instance:
will copy the MAYSALES.RPT file from the hard disk onto a
diskette in the B drive. This time, note that both source and
target drive letters were used. This is because neither drive was
the system default drive.

Wildcards

Copying files using wildcards in the filenames can be efficient,
but it can also be dangerous. When using wildcards, always
make sure you won't overwrite or erase another file. For
example:
will copy all of the files ending in SALES.RPT to the B drive.
The command:
5-12 Using Floppy Disks