Using A Password - Epson ActionTower 8000 User Manual

Using a Password

Using SETUP, you can define both a Supervisor level password
and a User level password. You can also specify whether a
password is required when you start the system. In addition,
the password can control who has access to the diskette drives.
If you enabled the
you must enter the Supervisor or User password every time
you turn on or reset the computer. If you enter a password but
disable the
password when you start SETUP.
If you set the
can access a diskette drive only if you entered the Supervisor
password when you started your system. If you entered a User
password when you started the system but the
access
when you access the diskette drive.
When you need to enter your password, you'll see the Security
Check window containing this prompt:
Enter password:
As you type your password, you see a rectangle for each
character you type. When you press Enter, the computer loads
the operating system (or starts SETUP).
If you don't enter the correct password the first time you type
it, you can try two more times. If you haven't entered the
correct password on the third try, the computer locks up to
prevent unauthorized access. You see the message:
SYSTEM DISABLED
Password on boot
Password on boot
Diskette
option is set to Supervisor, you see an error message
option, you must enter the
access option to Supervisor, you
Using Your Computer
option in SETUP,
D i s k e t t e
3-11