Epson ActionTower 8000 User Manual page 38

The Integrated
the table below.
Integrated peripherals options
Option
COM 1
COM 2
LPT port
LPT Mode
Diskette
controller
CMD
Enhance
Mode 3
* Default setting
Peripherals
Settings
IRQ 4 * (COM1)
3F8,
IRQ 3 * (COM2)
2F8,
IRQ 4
338,
IRQ 3
238,
3E8, IRQ 4
2E8, IRQ 3
2E8, IRQ 4
2E0, IRQ 3
IRQ 4
220,
IRQ 3
228,
Auto
Disabled
IRQ 7 *
378,
IRQ 7
278,
3BC, IRQ 5
IRQ 5
378,
IRQ 5
278,
3BC, IRQ7
Auto
Disabled
Standard
Bi-Directional*
ECP
Enabled *
Disabled
Enabled *
Disabled
Running SETUP and Installing Drivers
options are described in
Description
Assign the address for the built-in
primary and secondary serial
ports: the Auto setting detects
any optional ports you may have
installed and sets the built-in ports
automatically based on the
optional port settings to avoid
conflicts (if no optional ports are
installed, Auto sets the built-in
ports to their default settings): the
Disabled setting disables the
port(s)
Assigns the address for the built-in
parallel port: the Auto setting
detects any optional ports you
may have installed and sets the
built-in port automatically based
on the optional port settings to
avoid conflicts (if no optional
ports are installed, Auto sets the
built-in port to the default setting):
select Disabled to disable the
port
Sets the parallel port mode to:
Unidirectional AT mode
Bidirectional
PS/2 mode
Extended Capabilities Port
mode
Enables or disables the built-in
diskette drive controller
Enables or disables the CMD
driver that automatically checks
your drive's IDE modes
2-9