4. Position the connector on the cable so that the red wire
aligns with pin 1 on the drive.
5.
Make sure the holes in the cable connector fit over all the
pins; then push in the connector.
Caution
I f y o u d o n o t c o r r e c t l y a l i g n t h e h o l e s w i t h t h e p i n s , y o u
c o u l d s e v e r e l y d a m a g e y o u r h a r d d i s k d r i v e w h e n y o u
push in the connector.
6. Now locate one of the power supply cables that lead from
the power supply. (They have multi-colored wires and a
plastic connector on the end.)
lnstalling and Removing Drives in the Slimline Computer
I
5-9