Loading Instructions - Excalibur EWS SD130 Installation And User Manual

1.4)

Loading Instructions

Step 1: Check the product upon removal and remove from box packaging checking for any shipping
damage or shortages that must be reported to Excalibur Water Systems immediately for confirmation.
Step 2: Insert distributor(s) inside of media mineral tank(s) so it is positioned properly in the bottom
centre groove. If not already sized properly cut the top of the distributor pipe ½ - ¾" above top of tank
opening and clean off and excess PVC materials with grit cloth.
Step 3: Plug the top inlet opening of the distributor (Hub & Lateral) or bottom stack with a clean cloth,
rag, or tape to prevent any gravel or resin from entering into the distributor tube.
Step 4: Load the gravel under bedding onto the mineral tank using a funnel or some sort of loading
devise. If multiple layers of gravel with different sizes being utilized always load the largest gravel size in
diameter to the smallest last.
Step 5: Load the water softening cation exchange resin also by the use of a funnel or some sort of
loading device until all resin is inside of mineral tank. If loading a duplex system that has two tanks
divide the resin and gravel up equally when loading.
Step 6: Remove top opening cover of the distributor carefully not to move or disturb the distributor
tube not allowing any debris or materials to get inside of the now loaded softener(s).
Step 7: Thread on control valves onto top opening tanks be sure to check and verify that the O-ring on
the bottom base of the control valve is present and properly lubricated with silicone. Tighten control
valve(s) clockwise until you have reached the end of the thread and have secured a water tight seal. (If
control valves that utilize quick connect collars thread the collars the same into the tanks then attach
control valves).
Step 8: Precede now with the unit(s) in their proper installation locations to run piping and materials for
all inlet, outlet, and drain connections properly with isolation valves and test ports for future water
tests. Also, unions should be included in installation materials for easy future servicing of the control
valves when necessary on all inlet, outlet, and drain lines.
BARRIE • ONTARIO • CANADA TF: 705.733.8900 WWW.EXCALIBURWATER.COM