User Displays; Setting Time Of Day - Excalibur EWS SD130 Installation And User Manual

SOFTENER INSTALLATION AND USER GUIDE
2.3)

User Displays

User Display 1
2.4)

Setting Time of Day

User display-Time of Day
BARRIE • ONTARIO • CANADA TF: 705.733.8900 WWW.EXCALIBURWATER.COM
When the system is operating, one of five displays may be shown.
Pressing NEXT will alternate between the displays shown below.
User 1
Typical user display. Shows volume remaining to regeneration. This
screen will not be viewed if the control is set for time-clock operation.
User 2
Displays number of days to next regeneration.
User 3
Flow Rate.
Displays present flow rate.
User 4
Displays total volume in gallons since last reset. If a meter is not used
this display will be shown but 0 will be displayed.
PRESS ▼ FOR 3 SECONDS TO RESET TO 0.
User 5
Shows current time.
Push NEXT until time of day screen is displayed.
Press and hold ▼ until SET TIME is displayed and the hour flashes
once. Press ▲ or ▼ until the correct hour is displayed.
Then press NEXT. The minutes will flash. Press ▲ or ▼ until the
correct minute is displayed.
Press NEXT to return to the User Displays.
Time of day should only need to be set after power outages lasting
more than 8 hours, if the battery has been depleted and a power
outage occurs, or when daylight saving time begins or ends.
16