Overflow Line Connection; Drain Line - Excalibur EWS S130 Installation And User Manual

SOFTENER INSTALLATION AND USER GUIDE
1.9)

Overflow Line Connection

The overflow drain line is used where overflow of the brine tank can damage the floor finishing or
structure. The brine tank line is equipped with safety float valve which prevents the overflow so, the
overflow line is only used in case is overflow float valve fails. The overflow line will transfer fluid from
brine tank to the drain hence prevents the spillage.
1.10)

Drain Line

• The size of the drain must be according to the specifications.
Leave minimum of 6" gap between flow control fitting and solder joints. The gap less than this
•
can damage the flow control.
• Use ¾" or 1" tubing for drain line according to the specifications.
• If the drain line is elevated and then emptied into the drain below the level the of control valve
the 7" loop should make at the end of drain line.
• The air gap between the drain and the end of the drain line must be twice the diameter of the
tube.
• The strap must be tied at the end to secure the line.
BARRIE • ONTARIO • CANADA TF: 705.733.8900 WWW.EXCALIBURWATER.COM
8