Start Up Instructions - Excalibur EWS S130 Installation And User Manual

SOFTENER INSTALLATION AND USER GUIDE
1.13)

Start Up Instructions

Keep the bypass valve in bypass operation by moving both the handles into the center direction
•
of the bypass valve. Now the untreated water is being supplied to house. Open the faucet until
water comes clear out of it. The initial water can be dirty because of installation debris. Now
inspect the leaks in plumbing.
Manually add approximate 5 gallons of water to brine tank so that level reaches air check valve.
•
Press and hold the "REGEN" button down for 5 seconds to start manual regeneration. The drive
motor will start the backwash cycle and countdown time begins. Turn the inlet bypass valve
handles halfway into the direction of service operation. Once the steady water flows out of
drain then fully open the bypass valve into the direction of service operation.
• When the water become clear in drain line then press the regen button to advance the
regeneration in brine cycle. Fully open the faucet and check if water is being drawn from brine
tank. Allow this cycle to run for 3 minutes.
• Press REGEN button to advance the regeneration to rinse cycle. The water will come through the
drain. Allow this process until water coming through the drain becomes clear.
• Add salt to the tank and allow ample time to dissolve it in water to become brine solution.
BARRIE • ONTARIO • CANADA TF: 705.733.8900 WWW.EXCALIBURWATER.COM
12