Sony MDR-Z1R Service Manual page 6

MDR-Z1R
2-5. HOUSING ASSY, HANGER ASSY
Note 1: L-ch and R-ch can be similarly disassembled. The illustration
of R-ch is used for explanation.
– R-ch –
6 holder hanger (L)
2 two tapping screws
(P2 5)
hole
lower side
4 housing assy
1 sealing rear cushion
Note 2: When installing the sealing rear cushion,
affix the glossy surface to the housing assy.
h h h
1 Pass the jack cable.
groove
hole
holder hanger (R)
2 Align the hole and groove.
6
7 hanger assy
5 holder
hanger (R)
3 Draw the jack cable
out of the hole.
2 two tapping screws
(P2
1 Pass the jack cable into
3 Install the holder hanger (R) while
R
hanger assy
holder hanger (R)
h h
Note 4: Identify the holder hanger (L) and holder hanger (R)
by looking at the engraving on the parts.
"R" : holder hanger (R)
5)
c c
the housing assy hole.
gently pulling the jack cable in the
direction of the arrow.
Note 3: Check that the holder hanger
(R) is not raised.
holder hanger (L)
holder hanger (L)
h h h
"L" : holder hanger (L)
holder hanger (R)
2 Press the jack cable into
the holder hanger (R)
groove.
holder hanger (R)
hole groove
1 Align the hole and groove.
R