Sony MDR-Z1R Service Manual page 5

2-3. TWIST HOLDER, HOUSING BLOCK
Note: L-ch and R-ch can be similarly disassembled. The illustration of
R-ch is used for explanation.
1 Extend the slider
in the direction
of the arrow.
– R-ch –
2-4. FRONT PLATE ASSY
Note 1: L-ch and R-ch can be similarly disassembled. The illustration
of R-ch is used for explanation.
Take care not to damage the U-shaped groove.
Note 2: When installing the front plate
block, be careful of the wire
getting pinched.
(Check that it is secured using
the rib and groove as shown in
the figure right before installing)
Take care so that the wire is not positioned over the rib.
– –
3 Remove the
two solders.
rib
4 front plate assy
Note 3: When installing the front plate assy,
2 ornamental tapping screw
(M1.7
2 Remove the front plate block
rib
in the direction of the arrow.
1 tapping screw
groove
groove
1 four tapping
align the two ribs and two grooves.
4)
4 twist holder
(
[natural]
Note 5: Perform the soldering
work in 2 seconds or
less.
Note 6: Take care so that
the solder does not
touch the bond.
(P2 5)
(
Note 6: Take care so that
the solder does not
touch the bond.
1 tapping
screw
(P2 5)
[natural]
Note 5: Perform the soldering
screws
work in 2 seconds or
(P2 5)
less.
MDR-Z1R
2 ornamental tapping screw
(M1.7 4)
3 shaft stopper
5 housing block
Wire attachment direction.
front plate assy
mark
Note 4: The mark side
is red wire.
[red]
Note 5: Perform the soldering work
in 2 seconds or less.
[red]
Note 5: Perform the soldering work
in 2 seconds or less.
mark
Note 4: The mark side
is red wire.
front plate assy
Wire attachment direction.
wire
wire
5