7. Push the throttle control rearward to stop position.
8. Tighten the throttle cable stop.
a) Push the throttle cable up (G) and at the same
time push the throttle cable stop down (H).
I
b) Keep the pressure on the throttle cable stop and
throttle cable. Tighten the screw (I) for the
throttle cable stop.
9. Install the spring and the throttle cable stop.
1726 - 001 -
10. Move the throttle control from stop position (L) to idle
H
G
11. If the throttle lever does not move correctly, adjust
7.4 Engine
7.4.1 To do a check of the engine oil level LT 5005,
LT 6005, LT 6005 H
1. Put the product in an upright position.
2. Remove the oil tank cap and dipstick.
a) Put light pressure on the spring (J).
b) Tighten the throttle cable stop (K).
speed position (M) to operation mode position (N).
Make sure that the throttle lever moves correctly.
N
the positions of the washers and the nuts.
K
J
M
L
Repair and servicing - 23