Description Of Operation - Taie FA Series Operation Manual

9.5.2

Description of operation

1. There are 2 patterns can be used，each pattern contains 8 segments.
2. Terminologies
Pattern
Ramp status：The status with changing SV.
Soak status ：The status with fixed SV.
3. Operating
I. "KEY" function (no changing parameter)
(RUN)
(HOLD)
+ SET(JUMP) ：Jump to previous segment.
+ SET (RESET)：Reset program procedure，PRO LED in panel will off.
II. Alarm Function：
ALD1 = "07"(Segment end alarm)，
AL1 ="2"(It means when segment 2 end,AL1 will act)，
ALT1 ="00:10" (Relay on time is 10 seconds).
＊ In this case，when program proceeds to segment 2 end，the relay of AL1 will
be on 10 seconds.
III. END function：
The Controller doesn't have END order, so if program procedure is less than 8
segments, please set the last segments OUT to "0". Program will end in this
segment. Otherwise，it will proceed 8 or 16 segments.
IV. Linking Function：
PTN=1 proceed pattern 1，contains 8 segments.
PTN=2 proceed pattern 2，contains 8 segments.
PTN=0 linking proceed pattern 1 and 2 totally 16 segments.
(Please set PTN1 and PTN2 at first，and then set PTN to 0)
V. Other function(＊refer to LEVEL 4)
SET 8_1=1 Program repeats.
SET 8_2=0 No power failure function.
SET 8_2=1 Enable power failure function.
(When power shut down and on again，the controller will start from the
segment which is near PV)
SET 8_3=0 Program starts from 0.
SET 8_3=1 Program starts from PV.
SET 9_2=0 Timer Unit = "Hour: Minute"
SET 9_2=1 Timer Unit = "Minute: Second"
All manuals and user guides at all-guides.com
：A program consists of some steps.
：Start program procedure，PRO LED in panel start flicking.
：Suspend program procedure，PRO LED in panel will stop
flicker but still light on.
34