Repairing; Troubleshooting - Stihl MSA 160.0 C Instruction Manual

English
► File each cutter with a round file so that the
following points are observed:
– Round file matches the chain pitch.
– File from the inside to the outside of the cut‐
ter.
– Hold the file at right angle to the guide bar.
– Maintain a filing angle of 30°.

20 Troubleshooting

20.1 Troubleshooting Chainsaw or Battery
Fault LEDs on the
battery
Saw does not 1 LED flashing
start when swit‐ green.
ched on.
1 LED emits
red light.
3 LEDs flash
red.
3 LEDs light
up red.
4 LEDs
flash red.
56
► File down the depth gauges with a flat file so
that they are level with the STIHL filing gauge
and parallel to the service mark. The STIHL fil‐
ing gauge must match the chain pitch.
► If you have any queries: Contact your STIHL
servicing dealer for assistance.

19 Repairing

19.1
The chainsaw, guide bar, saw chain and battery
cannot be repaired by the user.
► If the saw, guide bar or saw chain is damaged:
Do not use your saw, guide bar or saw chain,
and contact your STIHL servicing dealer for
assistance.
► If the battery has a malfunction or is damaged:
Replace the battery.
Cause
State of charge of the
battery is too low.
The battery is too
warm or too cold.
Chainsaw fault.
Chainsaw is too hot.
There is a fault in the
battery.
Repairing the Chainsaw and
Battery
Remedy
► Recharge the battery fully as described in
the User Manual for the STIHL AL 101,
301, 301-4, 500 chargers.
► Engage chain brake and remove battery.
► Allow the battery to cool down or warm
up.
► Engage chain brake and remove battery.
► Clean electrical contacts in the battery
compartment.
► Insert battery.
► Disengage the chain brake.
► Switch on the chainsaw.
► If 3 LEDs continue to flash red: Do not
use your chainsaw and contact your
STIHL servicing dealer for assistance.
► Engage chain brake and remove battery.
► Allow the chainsaw to cool down for
20 minutes.
► Engage the chain brake, remove and refit
the battery.
► Disengage the chain brake.
► Switch on the chainsaw.
► If 4 LEDs continue to flash red: Do not
use the battery; contact a STIHL authori‐
zed dealer.
19 Repairing
0458-024-9801-A