Hardware Installation
To remove a module from the DIN rail:
1. Pull down the clips at the bottom of the module.
2. Pull the bottom of the module out and lift it up.
Flat Surface Mounting
To mount an RDR2S-A module on a flat surface:
1. Make sure no connectors obstruct access to the clips on the bottom of the
module. If necessary, remove the connectors.
2. Fully extend the bottom clips.
3. Mount the module to the surface with mounting screws.
4. Replace the connectors, if previously removed.
Fully extended
clips
(connectors
are removed)
Power Source
See the following table for power requirements.
Parameter
Input voltage
Input current
Power
4
S300-DIN-RDR2SA Module
Value
+12 to 24VDC, 16 o 24VAC
1A at 24V, 2A at 12V
24W
This document contains confidential and proprietary information of Johnson Controls, Inc.
24-10239-472 Rev. A
© 2007 Johnson Controls, Inc.