Setting Top Of Form (Tof); Forms Tear-Off Off (Default Setting) - Oki ML490 User Manual

Setting Top of Form (TOF):

Forms Tear-Off OFF (Default Setting)

Important!
If you turn the platen knob when the printer is on, the Top of
Form misaligns. Always turn the printer off before turning
the platen knob!
Note: The first line prints at the red line (1) of the plastic
paper shield on the printhead.
14
Microline 490/491 User's Guide
With paper loaded and the printer on and selected:
1 Press (1) to take the printer off line.
SEL | MENU
The SEL light goes out.
2 Press and hold (2), then
SHIFT
Note: When you begin pressing the Micro Feed key, the
printhead will move to the right.
• Press
LF | Micro Feed Down
paper moves down).
• Press
FF/LOAD | Micro Feed Up
(the paper moves up).
3 When you have the TOF set where you want it, press and
hold (2), then press
SHIFT
setting.
The printhead moves back to the left margin.
4 Press (1) to save the setting and place the printer
SEL/MENU
back on line.
Note: To reset the Top of Form to the factory default, see
"Resetting Top of Form to the Factory Default" later in
this chapter.
(3) to set the TOF higher (the
(4) to set the TOF lower
(7) to engage the new
QUIET/TOF