Setting Top Of Form - Oki MICROLINE 385/6 Handbook

Setting Top of Form
If Form Tear Off is ON, hold down the TOF/QUIET button and press:
FORM FEED to move the paper up, or
LINE FEED to move the paper down.
This moves the paper in very fine increments - Узво inch to be exact - so you с
the top of form precisely. The amount you can move the paper down using this
limited to avoid potential paper jams.
M O D E LINE
FEED
Hold down
FORM PARK
FEED \ / Q U I E T
FONT
COURIER R O M A N
PRESTIGE G O T H I C
s' , i:
B O I D
PRINT
A L A R M EXIT / GROUP ITEM \ SET PRINT
M E N U
4
.
"Push to move up
PO\ .'ER Push to move down
CHARACTER PITCH
The lower red line on the paper shield shows the baseline of the current printir
to help you place the top of form where you want it.
When the top of form is set where you want it, press the TOF/QUIET button. This
the position permanently in the printer's memory - even when the printer is turne
you reset it.
If Form Tear Off is OFF, adjust the top of the form by turning the platen knob, the
TOF button. (The SEL light should be out). The lower red line on the paper shield
baseline of the current print position to help place the top of the form where you
Important: Make sure the paper is held in place by the bail. If the top of the page is set below tt
will catch on the bail and cause a jam.