PC-8500/ PCX-720
It is imperative that Human Touch
products are repaired in a manner that ensures product safety and regulatory compliance and that is fully consistent with the practices used
®
during the manufacturing process. Therefore, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these repair
instructions. Failure to adhere to these instructions voids the product warranty and releases Human Touch from all liability for injury or product damage resulting from the repair.
Tools Required: Pliers, small flat-head screwdriver
NOTE: SAVE ALL REMOVED PARTS FOR USE DURING REASSEMBLY
REMOVING THE CONTROL MODULE
1. Raise the footrest, then unplug the chair.
2. Using two people, gently lay the chair on its left-hand side.
3. Locate the cable bracket that secures the three cables to the control module (Fig.1).
4. Holding the ends of the bracket, squeeze inward on the left-hand side, lift upward to disengage it from the control module, then remove the bracket (Fig.2).
5. Disconnect all three cables from the control module.
6. Locate the screw that secures the front of the control module to the backrest actuator, then use a Phillips-head screwdriver to remove it (Fig.3).
Bracket
(Fig.1)
REPLACING THE CONTROL MODULE
Bracket
(Fig.2)
June 23, 2015
SERVICE LEVEL: 3
Front of the control module
(Fig.3)
1