Human Touch Perfect Chair PC-085 Replacing

PC-085
Tools required: 4 mm (5/32") Allen Key, flat-head screwdriver, nail clipper or other instrument suitable for cutting zip ties
SAVE ALL REMOVED PARTS FOR USE DURING REASSEMBLY
REMOVING THE ARMREST
1. Using a flat-head screwdriver, pop out the inside side panel (it is connected to the chair using three plugs) (Fig.1).
2. If you are replacing the left-hand armrest, locate the cables connected inside the armrest, then disconnect them (Fig.2).
NOTE: If there is a zip tie in the way, cut and remove it.
3. Using a 4 mm (5/32") Allen Key, remove the two screws that hold the armrest in place (and their washers), then remove the armrest
from the chair (Fig.2).
Side panel
(Fig.1)
REPLACING AN ARMREST
3 plugs
PC-085IS-AR-A0
Cable
(Fig.2)
SERVICE LEVEL: 2
1