Radio; Fm Radio; Tuning To Radio Stations; Storing Preset Radio Stations - Philips WAC3500 User Manual

8. Radio

8.1 FM Radio

8.1.1 Tuning to radio stations

1
Connect the supplied FM wire antenna to the
Center (see 3.Installation)
2
Check that the set is switched on or in standby
mode (see 5.Basic functions)
3
Press HOME and use the navigation controls
3 or 4 and 2 to select Radio > FM Tuner
➜
Playback screen appears. Display shows:
Radio, the radio station frequency and a pre-
set number (if already programmed)
4
Press and hold 3 or 4 until the frequency in
the display starts running.
➜
The radio automatically tunes to a station of
sufficient reception. Display shows Searching
during automatic tuning
➜
If a station is received in stereo,
shown
➜
When you are receiving an RDS station,
is shown
5
Repeat Step 4 if necessary until you find the
desired radio station
●
To tune to a weak station, press 3 or 4 briefly
and repeatedly until optimal reception is
detected.
AUX MARK/UNMARK VIEW
REC
CLEAR
40
is
SEARCH
MENU
OK

8.1.2 Storing preset radio stations

You can store up to 60 preset radio stations in
the memory.
Autostore: automatic programming
Autostore automatically starts programming
radio stations from Preset 1. Available stations
are programmed in the order of radio
frequencies: RDS stations followed by FM
stations. A maximum of 10 RDS stations will be
stored (from Preset 01 to Preset 10).
1
To select Autostore radio,
a. Press MENU
b. Use the navigation controls 3 or 4 and 2 to
select Autostore radio
➜
Display shows: Autostore Please wait...
➜
After all the stations are stored, the first
autostored preset station will then play
automatically.
Manual programming
1
Tune to your desired radio station (see 8.1
Tuning to radio stations).
2
Press MENU and use the navigation controls
3 or 4 and 2 to select Save to Preset.
➜
The display shows:
3
Press 3 or 4 to select your desired preset
number.
4
Press OK/2; or 2
➜
Current radio station is stored to that preset
location.