Table of Contents
Advertisement
Important notes for users
in the U.K.
Mains plug
This apparatus is fitted with an approved 13-
Amp plug.To change a fuse in this type of plug,
proceed as follows:
1 Remove fuse cover and fuse.
2 Fix the new fuse which should be a BS1362 5-
Amp, A.S.T.A. or BSI approved type.
3 Refit the fuse cover.
If the fitted plug is not suitable for your socket
outlets, it should be cut off and an appropriate
plug should be fitted in its place.
If the mains plug contains a fuse, it should have
a value of 5 Amp. If a plug without a fuse is
used, the fuse at the distribution board should
not be greater than 5 Amp.
Note: The severed plug must be disposed, so as
to avoid a possible shock hazard due to it being
inserted into another 13-Amp socket.
How to connect a plug
The wires in the mains lead are colored
using the following codes: blue = neutral
(N), brown = live (L).
●
As these colors may not correspond with
the color markings identifying the terminals
in your plug, proceed as follows:
– Connect the blue wire to the terminal
marked N or colored black.
– Connect the brown wire to the terminal
marked L or colored red.
– Do not connect either wire to the earth
terminal in the plug, marked E (or e) or
colored green (or green and yellow).
Before replacing the plug cover, make sure
that the cord grip is clamped over the
sheath of the lead and not simply over the
two wires.
Copyright in the U.K.
Recording and playback of any materials may
require consent. See Copyright Act 1956 and The
Performerb' s Protection Acts 1958 to 1972.
2
Advertisement
Table of Contents
