Table of Contents
Advertisement
Tagelus
®
Sand Filters
IMPORTANT: Before servicing any part of the filter, be
sure the circulation system is OFF and pressure has
been relieved from the filter. If there is sand already in
the filter, open the air relief valve and drain the water
before removing closure or sand.
1. Unscrew the clamp with a Phillips head P3
screwdriver.
2. Remove the clamp and valve.
3. Remove sand (if there is sand in the filter).
4. Lift the stand pipe up to the filter opening to remove
the old laterals from the hub.
5. Then remove the standpipe and hub from the filter.
6. Insert new standpipe and hub through the filter
opening.
7. After inserting the new stand pipe and hub into the
filter opening, hold the stand pipe so that the hub
can be reached easily to begin inserting the new
laterals.
8. Assemble the six (6) new laterals into the hub.
Insert laterals with tabs vertical, then 1/4 turn to
align tabs horizontally to fit.
9. After new laterals are attached, insert complete
assembly (laterals, hub, and stand pipe) and fit the
hub over the center pipe in the bottom of the filter.
10. Put sand back into the filter.
Follow the sand specifications on page 4.
11. Reattach the clamp and the valve to the filter.
12. After sand is ready, proceed to "Start Up
Instructions" on page 5.
Failure to position the Automatic Air Vent inside of the Closure will allow excessive trapped air to accumulate in the filter. Trapped
air and the closure not properly closed can cause the closure to separate and could cause severe bodily injury and/or property
damage.
(bottom of tank)
Be sure hub fits securely over center pipe at the bottom
CLEARPRO TECHNOLOGY
®
Remove filter clamp with wrench and lift
valve off of the filter.
Center Pipe
Attach new laterals - Align tabs horizontally.
of the filter tank.
Filter Laterals Extension Kits Installation and User's Guide
3
Ph
P3
Lateral
Tabs
Advertisement
Table of Contents
