Weider 6900 User Manual page 21

36. Attach a Shroud Support (19) and the bottom
of the Left Shroud (17) to the Base (1) and the
Stabilizer (2) with four M4.2 x 19mm Self-tapping
Screws (49); do not tighten the Self-tapping
Screws yet.
Repeat steps 35 and 36 to attach the Right
Shroud (not shown).
See steps 35 and 36. Tighten the M4.2 x 19mm
Self-tapping Screws (49).
37. Attach the Curl Pad (14) to the Curl Post (13)
with two M6 x 16mm Screws (62).
38. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENT, beginning on page 22.
Before you use the weight system, pull each cable a few times to make sure that the cables move smoothly
around the pulleys. If one of the cables does not move smoothly, find and correct the problem.
IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is
used. See the CABLE DIAGRAM on page 26 for proper cable routing. If there is any slack in the
cables, you will need to remove the slack by tightening the cables. See MAINTENANCE on page 25.
36
37
21
1
49
19
14
62
13
17
2
49