Bay Networks 5399 Manual page 217

CallDef_port_input_
flow_control
CallDef_port_
multisession
CallDef_port_password
specifies the method of flow control for input received through a connection.
You can enter:
• to disable flow control.
none
• to designate flow control by recognizing xon and xoff
xonXoff
characters.
• to indicate that flow control is delegated to a lower
hardware
level.
Type
RAC
Values
none, xonXoff, hardware
Default
none
Lists RAC Only, Flow Control, Modem, Call Defaults
enables two active windows on the DEC TD/SMP-supported(VT420 or VT330)
terminals that are dialed in to a RAC or an ISDN Primary Rate RAC. The feature
is available to all calls on which the VCI interface is configured.
Type RAC
Values enabled or disabled
Default enabled
Lists RAC Only, Call Defaults
defines a password for a RAC or an ISDN Primary Rate RAC call. You can use
this password as a back-up for host-based security if the security servers do not
respond, or as an additional line of security after you enter a user name and
password. For security reasons, Annex Manager displays this value as
.
unset
If you use SecurID, set
(" "). Refer to the Remote Access Concentrator Software Reference
for more information about SecureID.
Type
RAC
Values
0 to 15 characters
Default
unset
Lists
RAC Only, Modem, Modem Internal, Call Defaults, Synch
Call Defaults
Managing Remote Access Concentrators Using Annex Manager
Appendix A
to a null string
CallDef_port_password
RAC Parameters
or
set
A-27