Table of Contents
Advertisement
Prerequisites
•
Procedure steps
Step
1
2
3
4
Copyright © 2007, Nortel Networks
.
Verify that the SFP is the correct model for your network configuration.
Action
Remove the SFP from its protective packaging.
Grasp the SFP between your thumb and forefinger.
As shown in the following figure, insert the device into the slot on
the module.
Apply a light pressure to the device until it clicks and locks into
position.
CAUTION
Risk of equipment damage
SFPs are keyed to prevent incorrect insertion. If the SFP
resists pressure, do not force it; turn it over, and reinsert it.
Remove the dust cover from the optical bore and insert the fiber
optic connector.
Ethernet Routing Switch 4500 Series
Installation — SFPs and XFPs
NN47205-301 (324186-A) 01.04 Standard
5.1 6 December 2007
—End—
Installing an SFP 23
Advertisement
Table of Contents
